![]() ![]() You do not need to configure the Monitor Link because end-to-end link redundancy is implemented. The two uplink ports for interconnecting the CX910s are in load sharing mode. The two ports on the MZ510 are connected to one switch module for load sharing. Port trunk allow-pass vlan 20Ĭonfigure the CX910 (3) in the same way as the CX910 (1), and the CX910 (4) as the CX910 (2).Īfter the configuration is complete, the CX910 (1) and CX910 (2) function as one switch module, and the CX910 (3) and CX910 (4) function as one switch module. Proceed with the following configuration in the stacking system: interface Eth-Trunk 1 The two CX910s automatically set up a stacking system, the CX910 (1) functions as the stacking master, and the CX910 (2) functions as the stacking slave. Save the configuration on the CX910 (1) and CX910 (2) respectively and then restart them. The CX910 configuration is as follows: CX910(1): The two uplink ports for interconnecting the CX910s are configured with link aggregation in LACP mode, as shown in Figure 5-32.įigure 5-32 Networking topology of the MZ510s working with the CX910s in 802.3ad link aggregation mode The two ports connected to the same MZ510 are manually configured with link aggregation. The two devices at both ends of link aggregation must be of the same model, so that either the CX910 (1) and CX910 (2) or the CX910 (3) and CX910 (4) must be configured in stack mode. Which 802.11 standard works best in this situation 802. In addition, the client already has a wireless telephone system installed that operates at 2.4 GHz. Your client needs the network to support a data rate of at least 150 Mbps. This mode requires that the port on the peer device (CX910) must be configured with link aggregation that complies with IEEE802.3ad. You are designing a wireless network for a client. Set the bonding mode to 802.3ad, that is, the link aggregation mode complying with IEEE802.3ad. The IP addresses of the NIC team ports are 192.168.20.40/24 and belongs to VLAN 20.The IP addresses of the NIC team ports are 192.168.10.30/24 and belongs to VLAN 10.The IP addresses of the NIC team ports are 192.168.20.10/24 and belongs to VLAN 20. ![]() The IP addresses of the NIC team ports are 192.168.10.10/24 and belongs to VLAN 10.Port1 and Port0 are configured as a NIC team, using the 802.3ad mode.For details about port bonding, see section 3.7. ![]()
0 Comments
Leave a Reply. |